Page 4 - SuperLift-DataBook-Sheave-Blocks-SBEDN9

WARNING LIFTING DEVICE - GENERAL PRECAUTIONS LOAD RATINGS STATED ON ALL SUPERLIFT LIFTING DEVICES ARE APPLICABLE TO NEW OR AS NEW PRODUCTS ONLY AND APPLY TO THE MAXIMUM LOAD WHICH MAY BE SUPPORTED BY THE HEAD FITTING, UNDER NORMAL ENVIRONMENTAL CONDITIONS, SHOCK LOADINGS MUST BE TAKEN INTO ACCOUNT WHEN SELECTING LOAD RATINGS ON LIFTING DEVICES AS THESE LOADS ARE MUCH GREATER THAN STATIC LOADS. THE WORKING LOAD LIMIT (W.L.L.) OR SAFETY FACTOR ON ALL SUPERLIFT PRODUCTS MAY BE AFFECTED BY WEAR, MISUSE, OVERLOADING, DEFORMATION, CORROSION OR OTHER CONDITIONS, REGULAR INSPECTION MUST BE CARRIED OUT TO DETERMINE WHETHER USE CAN BE CONTINUED OR THE PRODUCT WITHDRAWN FROM SERVICE, SUPERLIFT LIFTING DEVICES SHOULD BE USED BY EXPERIENCED TRAINED PERSONNEL FAMILIAR WITH HOISTING SYSTEMS. All the products manufactured by SUPERLIFT are sold with the express understanding that the purchaser is thoroughly familiar with the safe and proper use and application of the product. Responsibility for the use and application of the products rests with the user. SUPERLIFT products are generally intended for tension or pull loads, side loading must be never be applied, as it exerts additional force or loading which the product is not designed to accommodate. Failure of the product can occur due to incorrect use, misapplication, abuse, or improper maintenance. Product failure could result in property damage, personal injury or death.  WORKING LOAD LIMIT - The maximum load or force the product is authorized to support in a particular service.  PROOF LOAD - The average force to which a product may be subjected to before deformation occurs.  SHOCK LOAD - A force that results from the rapid acceleration of a static load (jerking), these loads add significantly to the static load.  STATIC LOAD - A constantly applied force or load.  IMPROPER: Use of lifting devices could result in death or serious injury to avoid this -  NEVER: Exceed working load limit  NEVER: Hoist loads over or near people  NEVER: Work under or near hoisted loads  ALWAYS: Operate, inspect and maintain lifting equipment in accordance with all relevant safety standards. WHEN ATTACHING OR MOVING A LOAD, THE OPERATOR / RIGGER, MUST MAKE SURE OF ALL OF THE FOLLOWING:  The hoisting rope is free of kinks or twists and not wrapped around the load.  The load is attached to the Crane Hook by means of a sling or other approved device allowing for single or duplex (rams horn) hooks.  The sling and load will clear all obstacles or obstructions.  The load is balanced and secured before lifting the load more than a few inches.  Multiple lines are not twisted around each other.  The hook is brought over the load in a manner to prevent swinging.  There is no sudden acceleration or deceleration of the moving load.  Do not allow anyone to ride on a load or hooks.  Do not attempt lifts beyond the rated load capacity of a crane or slings.  Do not lift a load from the side. Centre the crane directly over the load before hoisting to avoid swinging the load.  Do not leave suspended loads unattended. Spare parts are available from SUPERLIFT & authorized resellers; replace all worn or damaged parts. USE ONLY GENUINE SUPERLIFT SPARE PARTS WHEN REPAIRING OR SERVICING SUPERLIFT PRODUCTS 1 All specifications & dimensions are subject to change without notice. Ph: +(613) 9357 0277 www.superlift.com.au Fax: +(613) 9357 0621